Journal Search Engine

to

Search Advanced Search Adode Reader(link)
Download PDF Export Citation Korean Bibliography PMC Previewer
ISSN : 1229-6783(Print)
ISSN : 2288-1484(Online)
Journal of the Korea Safety Management & Science Vol.14 No.2 pp.49-54
DOI :

복합기 커버 개폐용 힌지의 설계와 구조 해석

윤 여 권*, 양 광 모**, 김 도 석***
*유한대학교 기계설계과, **유한대학교 산업경영과, ***중앙대학교 기계공학부

Design and Structural Analysis on the Open and Close Hinge for Complex Machine

Do-Seok Kim***, Yeo-Kwon Yun*, Kwang-Mo Yang**
***School of Mechanical Engineering, Chung-Ang University
*Dept. of Mechanical Design, Yuhan College, **Dept. of Industrial Engineering, Yuhan College

Abstract

As all kind of industry has developed, metal structure and machine instrument use bolt, pin, rivet and welding for assembly and combination. For pin and hinge, dimension accuracy is crucial to keep the operation and safety of the structure and machine instrument. In case of complex machine, the hinge for cover open-loop system is one of the significant design elements. Most of the hinges are being imported and assembled sine they give high technology development cost for its unit cost position. The reason is that the localization of hinge is inadequate. As the demand increase and the necessity of localization grow, it is now more important than ever to develop low cost structure. By the low cost structure, a new technology could be obtained for electronic product and structural hinge since it would enable for complex machine hinge to be guaranteed, technologically. Open-loop hinge is the link type and designed for the structure to keep constant open-loop.
And, the hinge is examined in design stability by finite element analysis method. In this paper, the operation result is presented when the hinge for complex machine open-loop is designed for link type structure.
Hinge safety,Complex machine,Analysis
6 윤여권(49-54).pdf806.3KB

Reference

1.Herbert. H. Uhlig and R. Winston revie, "Corrosion and corrosion control" 157-162, 1984.
2.Shin, S. J., Lee, T. S. and Oh, S. I., "Three-dimensional Finite Element Analysis of Rubber Pad Deformation Part I : Development of Implicit and Explicit Methods", Trans. of KSME(A), Vol. 22, No. 1, pp. 111-120, 1998.
3.Kwon, Y. D., Kwon, H. W., Shin, S. M. and Lee, C. B., "Finite Element Analyses of Cylinder Problems Using Pseudo-General Plane Strain Elements(Planar Constraints)", Journal of the KSOE, Vol. 17, No. 5, pp. 66-75, 2003.
4.Kim, S. H., Huh, H., Song, J. H., "Application of the CAE Process for the Determination of Parameters in the Stamping Process of an Auto-body Member", 2004 Autumn Conference Proceeding of KSAE, Vol. 3, pp. 1086-1091, 2004
  1. SEARCH

  2. Online Submission

    http://submission.koreasafety.or.kr

  3. KSSM

    The Korean Society of Safety ManagementWaste Society

  4. Editorial Office
    Contact Information

    - Tel: +82.31.336.2844
    - Fax: +82.31.336.2845
    - E-mail: safety@mju.ac.kr